U0100 Lost Communication with ECM / PCM "A"
Diagnostic trouble codes · Vehicles built from Jan 2012
Also covers:
- U0122 Lost Communication with Vehicle Dynamics Control Module
- U0151 Lost Communication with Airbag ECU
- U1101 Lost Communication with Distance Control ECU
DESCRIPTION
The seat belt control ECU receives signals from the master cylinder solenoid (skid control ECU) and the center airbag sensor via the CAN communication line.The distance control ECU receives signals from the ECM via the CAN communication line.
| DTC Code |
DTC Detection Item |
Inspection Area |
| U0100 |
ECM communication error. |
|
| U0122 |
Skid control ECU communication error. |
|
| U0151 |
Center airbag sensor communication error. |
|
| U1101 |
Distance control ECU communication error. |
|
INSPECTION PROCEDURE
- HINT:
- When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harnesses of each ECU.
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here for LHD, Click here for RHD).
Result Result
Proceed to
OK
(DTC is not output)
A
NG
(for LHD)
B
NG
(for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
