2011-2013 Land Cruiser · Service Manual Vehicle Interior

U0122 Lost Communication with Vehicle Stability Control Module

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Also covers:

DESCRIPTION

The seat belt control ECU receives signals from the master cylinder solenoid (skid control ECU) and the center airbag sensor via the CAN communication line.
DTC Code
DTC Detection Item
Inspection Area
U0122
Skid control ECU communication error.
  1. CAN communication system
  2. Master cylinder solenoid (skid control ECU)
  3. Seat belt control ECU
U0151
Center airbag sensor communication error.
  1. CAN communication system
  2. Seat belt control ECU
  3. Center airbag sensor

WIRING DIAGRAM

  1. Refer to DTC U0122 (CAN communication system for LHD) (Click here).
  2. Refer to DTC U0122 (CAN communication system for RHD) (Click here).

INSPECTION PROCEDURE


1. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here for LHD, Click here for RHD).

    Result 
    Result
    Proceed to
    OK
    (DTC is not output)
    A
    NG
    (for LHD)
    B
    NG
    (for RHD)
    C



B
GO TO CAN COMMUNICATION SYSTEM (DIAGNOSIS SYSTEM) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (DIAGNOSIS SYSTEM) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← U0100 Lost Communication with ECM / PCM "A" (+ U0122, U0151, U1101) (from Jan 2012)U0235 Lost Communication with Cruise Control Front Distance Range Sensor (+ U1102) (from Jan 2012) →