REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- When removing the stripe tape, heat the vehicle body and stripe tape using a heat light.
- Use the same procedures for the RH side and LH side.
- Standard Heating Temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Stripe Tape
20 to 30°C (68 to 86°F)
- NOTICE:
- Do not heat the vehicle body and stripe tape excessively.
| 1. REMOVE FENDER STRIPE LH |
![]() ![]() |
for Type A:
Remove the fender stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
- HINT:
- For snorkel-equipped vehicles, there is no Fender Stripe RH.
for Type B:

Remove the fender stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
| 2. REMOVE FRONT DOOR STRIPE LH |
![]() ![]() |
for Type A:
Remove the front door stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
for Type B:

Remove the front door stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
| 3. REMOVE REAR DOOR OUTSIDE STRIPE LH |
![]() ![]() |
for Type A:
Remove the rear door outside stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
for Type B:

Remove the rear door outside stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
| 4. REMOVE FRONT QUARTER STRIPE LH |
![]() ![]() |
for Type A:
Remove the front quarter stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
Text in Illustration *a
for RH Side
for Type B:

Remove the front quarter stripe.Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
Text in Illustration *a
for RH Side
| 5. REMOVE REAR QUARTER STRIPE LH |
![]() ![]() |
Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
Text in Illustration *a
for RH Side





