2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. When removing the stripe tape, heat the vehicle body and stripe tape using a heat light.

Standard Heating Temperature:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Stripe Tape
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body and stripe tape excessively.


1. REMOVE FENDER STRIPE LH

  1. B309345
    for Type A:
    Remove the fender stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.

      HINT:
      For snorkel-equipped vehicles, there is no Fender Stripe RH.

  1. B309346
    for Type B:
    Remove the fender stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.


2. REMOVE FRONT DOOR STRIPE LH

  1. B309347
    for Type A:
    Remove the front door stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.

  1. B309348
    for Type B:
    Remove the front door stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.


3. REMOVE REAR DOOR OUTSIDE STRIPE LH

  1. B309349
    for Type A:
    Remove the rear door outside stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.

  1. B309350
    for Type B:
    Remove the rear door outside stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.


4. REMOVE FRONT QUARTER STRIPE LH

  1. B309351E01
    for Type A:
    Text in Illustration 
    *A
    for RH Side
    *1
    Fuel Lid
    Remove the front quarter stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.

  1. B309352E01
    for Type B:
    Text in Illustration 
    *A
    for RH Side
    *1
    Fuel Lid
    Remove the front quarter stripe.

    1. Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.


5. REMOVE REAR QUARTER STRIPE LH

  1. B309353E01
    Pull back an edge of the stripe tape and pull it parallel to the vehicle body to remove it.
    Text in Illustration 
    *A
    for RH Side
    *1
    Fuel Lid

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →