2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LHD vehicle and RHD vehicle.
  2. The procedures listed below are for the LHD vehicle.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

B183763
  1. Detach the 8 claws and remove the opening cover.


3. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

B180307E02
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 6 claws.

  1. Disconnect the connector and remove the No. 3 instrument panel register.


4. REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

B181944E02
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 6 claws.

  1. Disconnect the connector and remove the No. 4 instrument panel register.


5. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET

  1. B181495
    Remove the 4 bolts.

  1. B183745
    Pull the radio receiver to detach the 8 claws on the backside of the radio receiver.

  1. Disconnect the connectors and remove the radio receiver.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →