2011-2013 Land Cruiser · Service Manual Suspension

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

C172946E03

NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.

  1. Connect 3 dry batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRR*1, SHRL*2) and terminal 3 (SHG).

    HINT:
    *1: for RH
    *2: for LH

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for RH 
    Tester Connection
    Condition
    Specified Condition
    2 (SHRR) - 3 (SHG)
    Max. HI
    Approx. 4.1 V
    Normal
    Approx. 2.25 V
    Min. LO
    Approx. 0.45 V
    for LH 
    Tester Connection
    Condition
    Specified Condition
    2 (SHRL) - 3 (SHG)
    Max. HI
    Approx. 4.1 V
    Normal
    Approx. 2.25 V
    Min. LO
    Approx. 0.45 V

    NOTICE:
    Do not apply a voltage of higher than 6 V.

    If the result is not as specified, replace the rear height control sensor.

← REMOVAL (from Sep 2011)ADJUSTMENT (from Sep 2011) →