2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

E248559E01
Text in Illustration 
*a
Component without harness connected
(Rear Height Control Sensor Sub-assembly LH)
*b
Low (-)
*c
Normal
*d
High (+)

NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.

  1. Connect 3 dry batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the rear height control sensor sub-assembly LH and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHRL) and terminal 3 (SHG).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (SHRL) - 3 (SHG)
    High (+)
    Approx. 4.5 V
    Normal
    Approx. 2.25 V
    Low (-)
    Approx. 0.5 V

    NOTICE:
    1. Do not apply a voltage of higher than 6 V.
    2. Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →