2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the TOYOTA parking assist-sensor system, parking assist monitor system (w/ Side Monitor System), side monitor system and wide view front monitor system. When a malfunction occurs in this circuit, each system will be abnormal.

WIRING DIAGRAM

E251391E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)

  1. E245332E11
    Disconnect the parking assist ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F75-4 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F75-1 (+B) - F75-4 (GND1)
    Always
    11 to 14 V
    F75-8 (IG) - F75-4 (GND1)
    Engine switch on (IG)
    11 to 14 V
    F75-9 (ACC) - F75-4 (GND1)
    Engine switch on (ACC)
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Parking Assist ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning ECU Power Source Circuit (from Jan 2012)PRECAUTION (Sep 2011 – Dec 2011) →