2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Clearance Warning ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit is the power source circuit to operate the clearance warning ECU assembly.

WIRING DIAGRAM

E182726E71

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY- BATTERY AND BODY GROUND)
E251386E01
  1. Disconnect the clearance warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F12-17 (GND1) - Body ground
    Always
    Below 1Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F12-15 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    F12-15 (IG) - Body ground
    Engine switch off
    Below 1 V

Text in Illustration 
*a
Front view of wire harness connector
(to Clearance Warning ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning ECU Power Source Circuit (Sep 2011 – Dec 2011)ECU Power Source Circuit (from Jan 2012) →