U0123 Lost Communication with Yaw Rate Sensor Module
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Also covers:
- U0124 Lost Communication with Lateral Acceleration Sensor Module
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| U0123 |
There is no communication from the yaw rate sensor. |
|
| U0124 |
There is no communication from the yaw rate sensor (lateral acceleration sensor). |
|
- HINT:
- For vehicles with the vehicle stability control system.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- HINT:
- Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
- CAUTION:
- For vehicles with an SRS system:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| NEXT | |
| 2. CHECK FOR OPEN IN CAN BUS WIRE (YAW RATE SENSOR BRANCH WIRE) |
![]() ![]() |
Disconnect the E50 yaw rate sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
E50-3 (CANH) - E50-2 (CANL)
Ignition switch off
54 to 69 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (YAW RATE SENSOR - BATTERY AND BODY GROUND) |
![]() ![]() |
Connect the cable to the negative (-) battery terminal.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E50-1 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
E50-4 (IG) - Body ground
Ignition switch ON
11 to 14 V
|
|
||||
| OK | ||
| ||


