2011-2013 Land Cruiser · Service Manual Power Source / Network

U1126 Lost Communication with Parking Assist ECU

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U1126
There is no communication from the parking assist ECU.
  1. Power source circuit of parking assist ECU
  2. Parking assist ECU
  3. Parking assist ECU branch wire or connector

HINT:
For vehicles with the parking assist monitor system only.


WIRING DIAGRAM

C179811E04

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (PARKING ASSIST ECU BRANCH WIRE)
E158425E02
  1. Disconnect the F43 parking assist ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    F43-9 (CANH) - F43-10 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE PARKING ASSIST ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)
E158425E03
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F43-4 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F43-6 (+B) - Body ground
    Always
    11 to 14 V
    F43-14 (ACC) - Body ground
    Ignition switch ACC
    11 to 14 V
    F43-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE PARKING ASSIST ECU (Click here)


← U1117 Lost Communication with Accessory Gateway (+ B2779) (from Jan 2012)Skid Control ECU Communication Stop Mode (Sep 2011 – Dec 2011) →