2011-2013 Land Cruiser · Service Manual Power Source / Network

U1117 Lost Communication with Accessory Gateway

Diagnostic trouble codes · Vehicles built from Jan 2012

Also covers:

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U1117
There is no communication from the accessory bus buffer
  1. Accessory bus buffer CAN branch wire or connector
  2. Accessory bus buffer
B2779
There is no communication from the accessory bus buffer
  1. Accessory bus buffer CAN branch wire or connector
  2. Accessory bus buffer

WIRING DIAGRAM

C140665E02

INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


NEXT


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


3. CHECK FOR OPEN IN CAN BUS WIRE (ACCESSORY BUS BUFFER CAN BRANCH WIRE)
E207355E02
  1. Disconnect the E6 accessory bus buffer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E6-1 (CAN+) - E6-2 (CAN-)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Accessory Bus Buffer)



NG
REPAIR OR REPLACE ACCESSORY BUS BUFFER CAN BRANCH WIRE OR CONNECTOR (CAN+, CAN-)
OK

REPLACE ACCESSORY BUS BUFFER


← U1117 Lost Communication with Accessory Gateway (+ B2779) (Sep 2011 – Dec 2011)U1126 Lost Communication with Parking Assist ECU (Sep 2011 – Dec 2011) →