2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedure for LHD and RHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL WINDSHIELD WIPER ECU

  1. E160828
    Install the windshield wiper ECU with the screw.

  1. Connect the 2 connectors.


2. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

B180304
  1. Connect the connector.

  1. Attach the 3 claws to install the lower No. 2 instrument panel finish panel.

  1. Install the 4 bolts.


3. INSTALL INSTRUMENT PANEL BOX DOOR KNOB

B182549
  1. Attach the 2 claws to install the instrument panel box door knob.


4. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

B182550
  1. Attach the 6 claws to install the No. 3 instrument cluster finish panel garnish.


5. INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

B180302
  1. Attach the 4 claws to install the lower instrument panel.

  1. Install the 2 bolts.


6. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

  1. B189607E01
    Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 4 claws to install the front passenger side knee airbag.

  1. Install the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


7. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.


8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

B182552
  1. Attach the 4 claws to install the No. 2 instrument panel under cover.


9. INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

B186358
  1. Connect the connector.

  1. Attach the 6 claws to install the instrument side panel.


10. INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

B182551
  1. Attach the 6 claws to install the instrument side panel.


11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


12. CHECK SRS WARNING LIGHT
(Click here)
← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Sep 2011) →