2011-2013 Land Cruiser · Service Manual Suspension

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


REMOVE SUSPENSION CONTROL RELAY
  1. Remove the suspension control relay from the engine room relay block.


INSPECT SUSPENSION CONTROL RELAY (AHC)

  1. C149624E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the suspension control relay.


INSTALL SUSPENSION CONTROL RELAY
  1. Install the relay to the engine room relay block.


CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSTALLATION (from Sep 2011)COMPONENTS (Sep 2011 – Dec 2011) →