2011-2013 Land Cruiser · Service Manual Drivetrain

L4 Position Switch Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The four wheel drive control ECU judges whether the transfer is in L4 based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the ECM. The four wheel drive control ECU inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator when the transfer is in L4.

WIRING DIAGRAM

Refer to DTC P0818 (Click here).

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)

  1. C209926E19
    Disconnect the A27 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-21 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Four Wheel Drive control ECU)



NG
Go to step 2
OK

GO TO TRANSFER SYSTEM (INSPECTION) (Click here)

2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)

  1. C219460E02
    Disconnect the A38 ECM connector.

  1. Disconnect the A27 four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A38-21 (L4) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← Pattern Select Switch 2nd Start Mode Circuit (from Jan 2012)L4 Position Switch Circuit (from Jan 2012) →