2011-2013 Land Cruiser · Service Manual Drivetrain

L4 Position Switch Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The four wheel drive control ECU judges whether the transfer is in the L4 position based on the information from the limit switch inside the transfer shift actuator assembly which is detected by the ECM. The four wheel drive control ECU then inputs a signal to the combination meter assembly via CAN communication and turns on the 4LO indicator.

WIRING DIAGRAM

Refer to DTC P2772 (Click here).

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND)

  1. C162221E12
    Disconnect the four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-21 (L4) - Body ground
    Always
    10 kΩ or higher



NG
Go to step 2
OK

GO TO TRANSFER SYSTEM INSPECTION (Click here)

2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - ECM)

  1. C177782E17
    Disconnect the ECM connector.

  1. Disconnect the four wheel drive control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    A38-21 (L4) - Body ground
    Always
    10 kΩ or higher
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    A52-21 (L4) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← L4 Position Switch Circuit (Sep 2011 – Dec 2011)PRECAUTION (from Jan 2012) →