2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Rear Fog Light Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The main body ECU receives a rear fog light switch information signal from the light control switch (rear fog switch), and illuminates the rear fog lights.

WIRING DIAGRAM

E159799E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Operate the intelligent tester according to the steps on the display and select "Active Test".

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Rear Fog Light Relay
    Rear fog light
    ON or OFF
    -

    OK:
    Fog light turns on/turns off.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT FUSE (RR FOG, TAIL)
  1. Remove the RR FOG fuse and TAIL fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    RR FOG fuse
    Always
    Below 1 Ω
    TAIL fuse



NG
REPLACE FUSE
OK


3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BODY GROUND)

  1. E157348E01
    Disconnect the 2A ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2A-1 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (REAR FOG LIGHT ASSEMBLY - MAIN BODY ECU AND BODY GROUND)

  1. Disconnect the 2C ECU connector.E159809E01

  1. for LH:

    1. Disconnect the O6 rear fog light connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2C-8 (RFGO) - O6-2
      Always
      Below 1 Ω
      O6-1 - Body ground
      O6-2 - Body ground
      Always
      10 kΩ or higher

  1. for RH:

    1. Disconnect the O5 rear fog light connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2C-8 (RFGO) - O5-2
      Always
      Below 1 Ω
      O5-1 - Body ground
      O5-2 - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← Rear Fog Light Circuit (Sep 2011 – Dec 2011)Turn Signal Light Circuit (Sep 2011 – Dec 2011) →