INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY
|
 |
- Attach the 2 claws to install the hazard warning switch.
| 2.
INSTALL CLOCK ASSEMBLY
|
 |
- Install the clock with the 2 screws.
| 3.
INSTALL NO. 1 RADIO BRACKET |
 |
- Install the bracket with the 3 bolts.
-
Torque:
- 3.0 N*m{
30 kgf*cm
, 26 in.*lbf
}
| 4.
INSTALL NO. 2 RADIO BRACKET |
 |
- Install the bracket with the 3 bolts.
-
Torque:
- 3.0 N*m{
30 kgf*cm
, 26 in.*lbf
}
| 5.
INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET |
 |
Connect the connectors.
- Install the radio receiver with the 2 screws and 2 bolts.
-
Torque:
- Bolt:
- 12 N*m{
122 kgf*cm
, 9 ft.*lbf
}
| 6.
INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER |
 |
- Insert the cluster finish panel and attach the 10 claws on its backside to install it.
| 7.
INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
|
 |
Connect the connector.
Attach the 6 claws to install the No. 4 instrument panel register.
| 8.
INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
|
 |
Connect the connector.
Attach the 6 claws to install the No. 3 instrument panel register.
| 9.
INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY
|
 |
Attach the 8 claws to install the opening cover.
| 10.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).