Rain Sensor LIN Communication Malfunction
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The LIN communication of the components related to the rain sensor occurs between the rain sensor and windshield wiper ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When using the intelligent tester with the ignition switch off to troubleshoot:
- Connect the intelligent tester to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
| 1. CHECK HARNESS AND CONNECTOR (RAIN SENSOR - WIND SHIELD WIPER ECU AND OVERHEAD JUNCTION BLOCK) |


Disconnect the E85 ECU connector.
Disconnect the R11 sensor connector.
Disconnect the R7 junction block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R11-3 (MPX) - E85-7 (MPX1)
Always
Below 1 Ω
R11-4 (SIG) - R7-29 (IG2)
Always
Below 1 Ω
R11-1 (ES) - R7-4 (GND2)
Always
Below 1 Ω
R11-3 (MPX) - Body ground
Always
10 kΩ or higher
R11-4 (SIG) - Body ground
Always
10 kΩ or higher
R11-1 (ES) - Body ground
Always
10 kΩ or higher
Reconnect the R7 junction block connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
R11-4 (SIG) - Body ground
Ignition switch ON
11 to 14 V
|
|
||||
| OK | |
| 2. REPLACE RAIN SENSOR |
Temporarily replace the rain sensor with a new one (Click here).
Check the rain sensor function is normal.
- OK:
- Rain sensor function is normal
|
|
||||
| OK | ||
| ||
