2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. INSTALL LUMBAR SWITCH (w/ Lumbar Support)

B180760
  1. Install the switch with the 2 screws.


2. INSTALL FRONT SEAT CUSHION SHIELD LH
  1. w/ Lumbar Support:
    Connect the lumbar switch connector.

  1. for 4 Way Seat Type:

    1. B180780E01
      Attach the 3 claws in the order shown in the illustration to install the front seat cushion shield LH.

    2. Install the 2 screws.

  1. for 8 Way Seat Type:

    1. B180786E01
      Attach the 3 claws in the order shown in the illustration to install the front seat cushion shield LH.

    2. Install the 3 screws.

  1. B180757
    w/ Seatback Board:
    Connect the 2 rubber bands to the 2 hooks.

  1. B180756
    w/o Seatback Board:
    Connect the rubber band to the 2 hooks.


3. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

B185571
  1. Attach the claw to install the reclining adjuster release handle LH.


4. INSTALL VERTICAL SEAT ADJUSTER KNOB (for 8 Way Seat Type)

B180781
  1. Install the snap ring to the vertical seat adjuster knob.

  1. Install the vertical seat adjuster knob.


5. INSTALL VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat Type)

B180753
  1. Install the vertical adjusting handle with the 2 screws.


6. INSTALL VERTICAL ADJUSTER COVER LH (for 8 Way Seat Type)

B180752
  1. Attach the 2 claws to install the vertical adjuster cover LH.


7. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the front seat assembly (Click here).

← INSPECTION (from Sep 2011)INSTALLATION (from Jan 2012) →