INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT LUMBAR SWITCH LH (for LHD) |
 |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Switch Condition
|
Specified Condition
|
3 (B) - 4 (H)
|
Hold
|
Below 1 Ω
|
1 (R) - 2 (E2)
|
1 (R) - 2 (E2)
|
Off
|
4 (H) - 5 (E2)
|
1 (R) - 3 (B)
|
Release
|
4 (H) - 5 (E2)
|
If the result is not as specified, replace the lumbar switch.
| INSPECT LUMBAR SWITCH RH (for RHD) |
 |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Switch Condition
|
Specified Condition
|
3 (B) - 4 (H)
|
Hold
|
Below 1 Ω
|
1 (R) - 2 (E)
|
1 (R) - 2 (E)
|
Off
|
4 (H) - 5 (E)
|
1 (R) - 3 (B)
|
Release
|
4 (H) - 5 (E)
|
If the result is not as specified, replace the lumbar switch.