REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE UPPER RADIATOR SUPPORT SEAL
|
 |
Remove the 7 clips and upper radiator support seal.
| 3.
REMOVE FRONT FENDER APRON SEAL FRONT RH
|
 |
- Remove the 3 clips and front fender apron seal front RH.
| 4.
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
|
 |
- Remove the 2 nuts and No. 1 engine cover.
| 5.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
|
 |
- Loosen the hose clamp.
Disconnect the mass air flow meter connector and using a clip remover, detach the wire harness clamp from the air cleaner cap.
Detach the 4 clamps and remove the air cleaner cap.
| 6.
REMOVE NO. 1 AIR CLEANER HOSE
|
 |
- Loosen the hose clamp and remove the No. 1 air cleaner hose.
| 7.
REMOVE INTAKE AIR CONNECTOR
|
 |
- w/o Viscous Heater:
Disconnect the connector from the water temperature sensor.
Using a clip remover, detach the 3 wire harness clamps.
w/ Viscous Heater:
Disconnect the 2 connectors from the viscous with magnet clutch heater and water temperature sensor.
Using a clip remover, detach the 3 wire harness clamps.
- Loosen the 2 hose clamps and remove the 2 bolts and intake air connector.
| 8.
REMOVE RADIATOR RESERVOIR ASSEMBLY
|
 |
- Disconnect the 2 hoses.
Remove the 3 bolts and radiator reservoir.
| 9.
REMOVE V-RIBBED BELT (w/ Viscous Heater)
|
 |
- Loosen the lock nut and turn the bolt counterclockwise.
Remove the V-ribbed belt.
| 10.
REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)
|
 |
- Remove the bolt, cover, No. 1 idler pulley and collar.
| 11.
REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)
|
 |
- Remove the nut and No. 3 idler pulley.
| 12.
REMOVE V-RIBBED BELT
|
 |
- Using a wrench to the V-ribbed belt tensioner bracket, turn the wrench clockwise and remove the V-ribbed belt.
| 13.
DRAIN POWER STEERING FLUID |
|
| 14.
DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE |
 |
- Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the vane pump.
| 15.
DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR |
 |
- Disconnect the connector.
| 16.
REMOVE PRESSURE FEED TUBE ASSEMBLY |
 |
- Remove the union bolt, union and disconnect the pressure feed tube.
Remove the gasket.
| 17.
REMOVE VANE PUMP ASSEMBLY |
 |
- Remove the 2 nuts and vane pump.
Remove the O-ring from the vane pump.