2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for Models with Jam Protection Function on 4 Windows)

  1. B165342E06
    for LHD:
    Check that the LED illuminates.

    1. Apply battery voltage to the master switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 18 (LED)
      Battery negative (-) → 12 (GND)
      LED illuminates

      1. If the result is not as specified, replace the multiplex network master switch assembly.
        Text in Illustration 
        *1
        LED
        *a
        Component without harness connected:
        (Multiplex Network Master Switch Assembly)

  1. B295575E01
    for RHD:
    Check that the LED illuminates.

    1. Apply battery voltage to the master switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 18 (LED)
      Battery negative (-) → 12 (GND)
      LED illuminates

      1. If the result is not as specified, replace the multiplex network master switch assembly.
        Text in Illustration 
        *1
        LED
        *a
        Component without harness connected:
        (Multiplex Network Master Switch Assembly)


INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for Models with Jam Protection Function on Driver Door Window Only)

  1. B294142E01
    for LHD:
    Check that the LED illuminates.

    1. Apply battery voltage to the master switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 3 (LED+)
      Battery negative (-) → 1 (E)
      LED illuminates

      1. If the result is not as specified, replace the multiplex network master switch assembly.
        Text in Illustration 
        *1
        LED
        *a
        Component without harness connected:
        (Multiplex Network Master Switch Assembly)

  1. B295576E01
    for RHD:
    Check that the LED illuminates.

    1. Apply battery voltage to the master switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 3 (LED+)
      Battery negative (-) → 1 (E)
      LED illuminates

      1. If the result is not as specified, replace the multiplex network master switch assembly.
        Text in Illustration 
        *1
        LED
        *a
        Component without harness connected:
        (Multiplex Network Master Switch Assembly)

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →