2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Models with Jam Protection Function on 4 Windows)

  1. B184456E19
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (UP) - 1 (GND)
    Manual up operation
    Below 1 Ω
    7 (DOWN) - 1 (GND)
    Manual down operation
    Below 1 Ω
    8 (AUTO) - 1 (GND)
    Auto up/down operation
    Below 1 Ω

    1. If the result is not as specified, replace the power window regulator switch assembly.

  1. Check that the LED illuminates.

    1. Apply battery voltage to the power window regulator switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 4 (LED)
      Battery negative (-) → 1 (GND)
      LED illuminates

      1. If the result is not as specified, replace the power window regulator switch assembly.
        Text in Illustration 
        *1
        LED
        *a
        Component without harness connected
        (Power Window Regulator Switch Assembly)


INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Models with Jam Protection Function on Driver Door Window Only)

  1. B107881E06
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (U) - 3 (B)
    2 (SD) - 1 (D)
    UP
    Below 1 Ω
    5 (SU) - 4 (U)
    2 (SD) - 1 (D)
    OFF
    Below 1 Ω
    5 (SU) - 4 (U)
    3 (B) - 1 (D)
    DOWN
    Below 1 Ω

    1. If the result is not as specified, replace the power window regulator switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly)

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →