2011-2013 Land Cruiser · Service Manual Steering

REMOVAL

Removal / installation · Vehicles built from Jan 2012

HINT:
  1. Use the same procedure RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. PRECAUTION

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
(Click here)

4. REMOVE POWER STEERING ECU ASSEMBLY

  1. C257348
    Remove the bolt

  1. Disconnect the connector remove the power steering ECU.

← COMPONENTS (from Jan 2012)INSTALLATION (from Jan 2012) →