2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2055 Radar Sensor Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

This DTC is stored when there is a malfunction in the communication from the millimeter wave radar sensor. This DTC is also stored when the vehicle information sent from the millimeter wave radar sensor is abnormal.
In these cases, perform initialization so that the millimeter wave radar sensor recognizes the vehicle information.
DTC Code
DTC Detection Condition
Trouble Area
B2055
There is a malfunction in the millimeter wave radar sensor or there is a problem with the initialization.
  1. Millimeter wave radar sensor
  2. Seat belt control ECU
  3. Distance control ECU

INSPECTION PROCEDURE


1. CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
  1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.

  1. Clear the DTC (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 40 km/h (25 mph) or more.

    2. Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.

  1. Check for DTCs (Click here).

    OK:
    DTC P1570 is not output.



NG
GO TO DYNAMIC RADAR CRUISE CONTROL SYSTEM (Click here)
OK


2. CHECK DTC (PRE-CRASH SAFETY SYSTEM)
  1. Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    OK
    (DTC B2055 is not output)
    A
    NG
    (for LHD)
    B
    NG
    (for RHD)
    C



B
REPLACE SEAT BELT CONTROL ECU (Click here)

C
REPLACE SEAT BELT CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← B2036 Power Supply Relay Malfunction Open (from Jan 2012)B2056 Axial Gap of Radar Sensor (from Jan 2012) →