B2036 Power Supply Relay Malfunction Open
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
If the seat belt control ECU judges that there is a malfunction in its internal circuit as a result of self-diagnosis, or if the power source voltage (+B) is not input to the seat belt control ECU, this DTC will be stored.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2036 |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- CAUTION:
- The pretensioner is built into the front seat outer belt assembly. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. INSPECT SEAT BELT CONTROL ECU (+B TERMINAL VOLTAGE) |
Disconnect the negative (-) battery terminal.

- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Disconnect the E41 connector of the seat belt control ECU.
Connect the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E41-7 (+B) - Body ground
Always
11 to 14 V
Result Result
Proceed to
OK
(for LHD)
A
OK
(for LHD)
B
NG
C
Disconnect the negative (-) battery terminal.
Reconnect the E41 seat belt control ECU connector.
Connect the negative (-) battery terminal.
|
|
||||
|
|
||||
| A | ||
| ||
