2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2059 Vehicle Speed Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

The seat belt control ECU receives vehicle speed information from the ECM and master cylinder solenoid (skid control ECU) via CAN communication.
The ECM receives vehicle speed information from the master cylinder solenoid (skid control ECU) through the combination meter.
This DTC is stored when there is a difference in the vehicle speed information from the ECM and master cylinder solenoid (skid control ECU).
DTC Code
DTC Detection Condition
Trouble Area
B2059
The vehicle speed information from the ECM and the vehicle speed information from the master cylinder solenoid (skid control ECU) are different.
  1. Combination meter
  2. ECM
  3. Master cylinder solenoid (skid control ECU)
  4. Seat belt control ECU
  5. Distance control ECU

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)
  1. Using the intelligent tester, enter the following menus: Body / Combination Meter / Data List.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed Meter
    Vehicle speed/
    Min.: 0 km/h (0 mph)
    Max.: 255 km/h (158 mph)
    Almost same as actual speed (when driving)
    The speed is indicated on the speedometer.

  1. Read the value displayed on the intelligent tester.

    OK:
    Vehicle speed displayed on the intelligent tester is almost the same as actual vehicle speed measured using speedometer tester (calibrated chassis dynamometer).



NG
REPLACE COMBINATION METER (Click here)
OK


2. CHECK DTC (MALFUNCTION IN CAN COMMUNICATION SYSTEM WITH ECM)
  1. Using the intelligent tester, clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    CAN communication system DTCs (U0073, U0100, U0122, U0126) are output
    (for LHD)
    B
    CAN communication system DTCs (U0073, U0100, U0122, U0126) are output
    (for RHD)
    C
    Pre-crash safety system DTC B2059 is output
    (for LHD)
    D
    Pre-crash safety system DTC B2059 is output
    (for RHD)
    E



B
GO TO CAN COMMUNICATION SYSTEM (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (Click here)

D
REPLACE SEAT BELT CONTROL ECU (Click here)

E
REPLACE SEAT BELT CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← B2058 Steering Angle Sensor (from Jan 2012)B2060 ABS Malfunction (Sep 2011 – Dec 2011) →