B2060 ABS Malfunction
Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This DTC is stored when a malfunction in the vehicle stability control system is detected. This circuit consists of the master cylinder solenoid (skid control ECU) and seat belt control ECU. Signals are sent from the master cylinder solenoid (skid control ECU) via the CAN communication line.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B2060 |
Malfunction in the brake system is detected. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DTC (CAN COMMUNICATION SYSTEM) |
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here for LHD, Click here for RHD).
Result Result
Proceed to
OK
(DTC U0122 is not output)
A
NG
(for LHD)
B
NG
(for RHD)
C
- HINT:
- DTC U0122: Lost Communication with Skid Control ECU
|
|
||||
|
|
||||
| A | |
| 2. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM) |
Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC is not output.
|
|
||||
| OK | |
| 3. CHECK DTC (PRE-CRASH SAFETY SYSTEM) |
Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
OK
(DTC B2060 is not output)
A
NG
(for LHD)
B
NG
(for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
