2011-2013 Land Cruiser · Service Manual Vehicle Interior

B2057 Yaw Rate Sensor

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

This DTC is stored when the vehicle is driven at a vehicle speed of 5 km/h (3 mph) or more and a malfunction occurs in the yaw rate sensor.
This circuit consists of the yaw rate sensor and seat belt control ECU.
DTC Code
DTC Detection Condition
Trouble Area
B2057
The vehicle speed is 5 km/h (3 mph) or more and a malfunction is detected in the yaw rate sensor.
  1. Yaw rate sensor
  2. Seat belt control ECU
  3. Distance control ECU

WIRING DIAGRAM

E158927E02

INSPECTION PROCEDURE


1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC C1234 is not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2. CHECK DTC (PRE-CRASH SAFETY SYSTEM)
  1. Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    OK
    (DTC B2057 is not output)
    A
    NG
    (for LHD)
    B
    NG
    (for RHD)
    C



B
REPLACE SEAT BELT CONTROL ECU (Click here)

C
REPLACE SEAT BELT CONTROL ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← B2056 Axial Gap of Radar Sensor (from Jan 2012)B2058 Steering Angle Sensor (from Jan 2012) →