C1232 Acceleration Sensor Stuck Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
Also covers:
- C1243 Acceleration Sensor Stuck Malfunction
- C1245 Acceleration Sensor Output Malfunction
- C1279 Acceleration Sensor Output Voltage Malfunction (Test Mode DTC)
DESCRIPTION
The skid control ECU (master cylinder solenoid) receives signals from the yaw rate sensor assembly via the CAN communication system.The yaw rate sensor assembly has a built-in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2). If there is trouble in the bus lines between the yaw rate sensor assembly and the CAN communication system, DTCs U0123 (yaw rate sensor communication trouble) and U0124 (acceleration sensor communication trouble) are stored.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1232 |
At a vehicle speed of 10 km/h (6 mph) or more, the fluctuation range of the signal from one of either GL1 or GL2 is below 80 mV and the fluctuation range of the signal of the other is higher than 1.9 V for 30 seconds or more. |
|
| C1243 |
The following condition repeats 16 times.
|
|
| C1245 |
The following condition continues for at least 60 seconds.
|
|
| C1279 |
Stored during test mode. |
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the yaw rate sensor assembly, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- After replacing the yaw rate sensor assembly, perform calibration (Click here).
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON.
Check if DTCs U0073, U0123, C1210 and/or C1336 are output (Click here).
Result Result
Proceed to
DTC U0073, U0123, C1210 and/or C1336 are not output
A
DTC U0073 and/or U0123 are output (for LHD)
B
DTC U0073 and/or U0123 are output (for RHD)
C
DTC C1210 and/or C1336 are output
D
|
|
||||
|
|
||||
|
|
||||
| A | |
| 2. CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Check that the yaw rate sensor assembly is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque. The sensor is not tilted.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (IG/+B/GND TERMINAL) |
Disconnect the yaw rate sensor assembly connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
E50-4 (IG) - Body ground
Ignition switch ON
11 to 14 V
E50-6 (+B) - Body ground
Always
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E50-1 (GND) - Body ground
Always
Below 1 Ω
| *a |
Front view of wire harness connector (to Yaw Rate Sensor Assembly) |
| Result |
Proceed to |
| OK (When troubleshooting in accordance with Diagnostic Trouble Code Chart) |
A |
| OK (When troubleshooting in accordance with Problem Symptoms Table) |
B |
| NG |
C |
|
|
||||
|
|
||||
| A | ||
| ||
