2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P1572 Improper Aiming of Radar Sensor Beam Axis

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

This DTC is stored when there is a problem with the millimeter wave radar sensor beam axis adjustment.
DTC Code
DTC Detection Condition
Trouble Area
P1572
The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the millimeter wave radar sensor beam axis is misaligned (0.15 seconds. or more).
Millimeter wave radar sensor

HINT:
If the beam axis deviates vertically by +/-2° or more and/or horizontally by +/-4° or more at a distance of 4.0 to 6.0 m (13 to 20 ft), this DTC is stored.


INSPECTION PROCEDURE

NOTICE:
When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (Click here).


1. ADJUST MILLIMETER WAVE RADAR SENSOR
  1. Refer to the adjustment (Click here).

    HINT:
    It is necessary to make the ECM recognize specification information (whether the vehicle is equipped with the dynamic radar or not). If this procedure has not been carried out, this DTC may be output.


NEXT


2. CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
  1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 50 km/h (30 mph) or more.

    2. Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.

  1. Check for DTCs (Click here).

    OK:
    DTC P1572 is not output.



NG
REPLACE MILLIMETER WAVE RADAR SENSOR (Click here)
OK

END


← P1570 Radar Sensor Malfunction (from Jan 2012)P1575 Warning Buzzer Malfunction (from Jan 2012) →