2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012


1. INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH
  1. Attach the 2 clips to install the power back door sensor assembly LH.

  1. Using a T25 "TORX" wrench, install the 6 screws.

  1. Connect the connector.


2. INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


3. INSTALL BACK DOOR GARNISH
  1. Attach the 14 clips to install the back door garnish.


4. INSTALL BACK DOOR SIDE GARNISH LH
  1. Attach the 3 clips and 2 claws to install the back door side garnish LH.


5. INSTALL BACK DOOR SIDE GARNISH RH
  1. w/o Power Back Door:

    HINT:
    Use the same procedure described for the LH side.

  1. w/ Power Back Door:

    1. Attach the clip and 4 claws to install the back door side garnish RH.


6. INSTALL CENTER BACK DOOR GARNISH
  1. Attach the 5 clips and 4 claws to install the center back door garnish.


7. INSTALL LOWER BACK DOOR STOPPER CUSHION
  1. Install the 2 lower back door stopper cushions with the 4 bolts.

← INSPECTION (from Jan 2012)COMPONENTS (from Jan 2012) →