SYSTEM DESCRIPTION
Troubleshooting · Vehicles built from Jan 2012
| TAIL GATE CLOSER SYSTEM DESCRIPTION |
The lower tail gate lock, built into the lower tail gate, sends an open/close condition signal to the No. 2 main body ECU and an open/close operation is performed by operating the lower tail gate lock motor LH and RH.
The latch is opened by the back door remote control so that the lower tail gate can be opened.
4 switches are built into the lower tail gate lock, and the No. 2 main body ECU monitors the status of each switch. The ECU controls latch "release/close" operations in response to the inputs from each switch.
Switch
Function
Lower tail gate courtesy switch
Detects whether lower tail gate is open or closed. This switch turns on when lower tail gate is open or ajar and turns off when it is fully closed.
Half-latch switch
Detects ajar position of latch. This switch turns on when latch is in open-latch position.
Pawl switch
Detects the tail gate position.
Close position switch
Detects fully closed position of latch. This switch turns on when latch is in over-latch position.
| FUNCTION OF MAIN COMPONENTS |
| Component |
Function |
| Back door remote control |
When the back door remote control is operated and a back door remote control signal is sent, the No. 2 main body ECU performs the lower tail gate open operation. |
| Lower tail gate lock |
Receives an operation signal from the No. 2 main body ECU to open/close the lower tail gate. Also detects the lower tail gate position signal through the built-in close position switch, half-latch switch and lower tail gate courtesy switch. |
| Combination meter |
Sends the vehicle speed signal to the No. 2 main body ECU via CAN communication. |