2011-2013 Land Cruiser · Service Manual Vehicle Exterior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

HINT:
  1. Use these following procedures to troubleshoot the tail gate closer system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result  
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (for LHD)
      B
      CAN DTC is output (for RHD)
      C


    B.

    C.
    A

    4.CHECK DTC OUTPUT*
    1. Starting with the lower tail gate closed, open and close the lower tail gate 6 times.

    2. Check for DTCs (Click here).

    3. Clear the DTCs (Click here).

    4. Starting with the lower tail gate closed, open and close the lower tail gate 6 times.

    5. Recheck for DTCs (Click here).

      Result  
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    5.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

      Result  
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here).

    2. Terminals of ECU (Click here).

    3. Data List / Active Test (Click here).

    NEXT

    7.REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Jan 2012)OPERATION CHECK (from Jan 2012) →