DATA LIST / ACTIVE TEST
System information · Vehicles built from Jan 2012
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body No. 4 / Data List.
According to the display on the tester, read the Data List.
Body No. 4 Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Handle Switch of tail gate panel
Back door remote control signal / ON or OFF
ON: Back door remote control pulled
OFF: Back door remote control free
-
Half Latch Switch RH
Half-latch switch RH signal / ON or OFF
ON: Lower tail gate open
OFF: Lower tail gate closed
-
Half Latch Switch LH
Half-latch switch LH signal / ON or OFF
ON: Lower tail gate open
OFF: Lower tail gate closed
-
Courtesy Switch RH
Lower tail gate courtesy switch RH signal / ON or OFF
ON: Lower tail gate open
OFF: Lower tail gate closed
-
Courtesy Switch LH
Lower tail gate courtesy switch LH signal / ON or OFF
ON: Lower tail gate open
OFF: Lower tail gate closed
-
Position Switch RH
Close position switch RH signal / ON or OFF
ON: Lower tail gate closed
OFF: Lower tail gate open
-
Position Switch LH
Close position switch LH signal / ON or OFF
ON: Lower tail gate closed
OFF: Lower tail gate open
-
Luggage Pawl Switch
Pawl switch signal / ON or OFF
ON: Lower tail gate lock motor operating
OFF: Lower tail gate open or closed
-
Fail Count RH
Number of malfunctions detected in lower tail gate lock RH / 0 to 5
Number of detected malfunctions displayed
-
Fail Count LH
Number of malfunctions detected in lower tail gate lock LH / 0 to 5
Number of detected malfunctions displayed
-
# Codes
Number of stored trouble codes / min.: 0, max.: 255
Number of DTCs displayed
-
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform the Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body No. 4 / Active Test.
According to the display on the tester, perform the Active Test.
Body No. 4 Tester Display
Test Part
Control Range
Diagnostic Note
Tail Gate Panel Open
Lower tail gate lock
ON / OFF
The back door must be open.