2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

U0073 Control Module Communication Bus OFF

Diagnostic trouble codes · Vehicles built from Jan 2012

Also covers:

DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the parking assist ECU.

HINT:
If CAN communication system DTCs are stored, they may also be stored in other systems.

DTC Code
DTC Detection Condition
Trouble Area
U0073
Control module communication bus off
CAN communication system
U0100
Lost communication with ECM
U0114
Lost Communication with 4WD Control ECU
U0126
Lost communication with steering angle sensor
U0130
Lost communication with VGRS
U0140
Lost communication with main body ECU

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Clear the DTCs.

    1. for LHD: Click here
    2. for RHD: Click here

  1. Check for DTCs.

    1. for LHD: Click here
    2. for RHD: Click here
    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C

HINT:
  1. If CAN communication system DTCs are stored, they may also be stored in other systems.
  2. If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
  3. If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
    1. for LHD: Click here
    2. for RHD: Click here



B
Go to CAN COMMUNICATION SYSTEM (Click here)

C
Go to CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1694 Steering Angle Initialization Incomplete (from Jan 2012)Image from Camera for Parking Assist Monitor is Abnormal (from Jan 2012) →