C1694 Steering Angle Initialization Incomplete
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1694 |
Maximum steering angle has not been memorized |
|
INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the parking assist ECU after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed (Click here).
- When "System initializing" is displayed on the parking assist ECU after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
| 1. PERFORM SETTINGS (STEERING ANGLE SETTING) |
Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.
Refer to steering angle setting (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC C1694 is not output.
- HINT:
- If DTC C1694 is output, perform the steering angle setting again.
- If DTC C1694 is output, perform the steering angle setting again.
- If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.
- If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.
|
|
||||
| OK | ||
| ||
