2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built from Jan 2012

HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms the listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected area below.

NOTICE:
The following inspection procedure of the side monitor system is described on the assumption that the navigation system is normal. If navigation system has any malfunction, first proceed with troubleshooting of the navigation system.

General 
Symptom
Suspected Area
See page
When the front and side monitor main switch on, the side monitor image is not displayed (screen is not black).
Proceed to ["CHK" message(s) are displayed on the SIGNAL CHECK screen]
Click here
Data List/Active Test - AISIC Output Status
Click here
GVIF cable
-
Parking Assist ECU
Click here
Multi-display assembly
Click here
When the front and side monitor main switch on, the side monitor image is not displayed (screen is black).
Data List/Active Test - AISIC Output Status
Click here
GVIF cable
-
Parking assist ECU
Click here
Multi-display assembly
Click here
When the front and side monitor main switch off, the side monitor image is displayed.
Proceed to ["CHK" Message(s) are Displayed on the SIGNAL CHECK Screen]
Click here
Multi-media module receiver assembly
Click here
Display Malfunction 
Symptom
Suspected Area
See page
Assist lines are not displayed.
Parking assist ECU
Click here
"System initializing" is displayed.
Correct the steering angle neutral point
Click here
Images from all cameras (rear and side television camera) are abnormal.
Data List/Active Test - AISIC Output Status
Click here
GVIF cable
-
Parking assist ECU
Click here
Multi-display assembly
Click here
Image from camera for side monitor is abnormal (parking assist monitor system is normal).
Proceed to [Image from Camera for Side Monitor is Abnormal]
Click here
Message indicating "System not ready" is displayed even after setting is finished.
Parking assist ECU
Click here
Side Monitor System Malfunction 
Symptom
Suspected Area
See page
"CHK" message(s) are displayed on the SIGNAL CHECK screen.
Proceed to ["CHK" Message(s) are Displayed on the SIGNAL CHECK Screen]
Click here
← CALIBRATION (from Jan 2012)TERMINALS OF ECU (from Jan 2012) →