2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

CB-10 System Microcomputer Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Also covers:

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
CB-10
System microcomputer malfunction
  1. Multi-media interface ECU
  2. USB device or "iPod"
CB-11
Media interface microcomputer malfunction
CB-12
CD-LSI (large scale integration) malfunction

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the engine switch off.

    HINT:
    When one of these DTCs has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the engine switch on (ACC).

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same DTC occurs again.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    Malfunction disappears.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE


← 74-40 Short in Speaker Circuit (from Jan 2012)CB-10 System Microcomputer Malfunction (+ CB-11, CB-12) (from Jan 2012) →