CB-45 USB Communication Error
Diagnostic trouble codes · Vehicles built from Jan 2012
Also covers:
- CB-46 iPod Control Error
- CB-47 iPod Communication Error
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
| DTC No. |
DTC Detection Condition |
Trouble Area |
| CB-45 |
Communication error with USB device |
|
| CB-46 |
"iPod" control software malfunction |
|
| CB-47 |
Communication error with "iPod" |
INSPECTION PROCEDURE
- HINT:
- After the inspection is completed, clear the DTCs.
| 1. REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
Turn the engine switch off.
- HINT:
- When one of these DTCs has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the engine switch on (ACC).
Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.
- HINT:
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
- If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
| NEXT | |
| 2. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 3. RECHECK FOR DTC |
Recheck for DTCs and check if the same DTC occurs again.
- HINT:
- If DTCs are detected frequently, replace the multi-media interface ECU.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
