REMOVAL
Removal / installation · Vehicles built from Sep 2011
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1.
REMOVE LOWER STEERING COLUMN COVER
|
 |
- Remove the 3 screws.
Detach the 2 claws to remove the lower steering column cover.
- NOTICE:
- Do not damage the tilt and telescopic switch.
| 2.
REMOVE UPPER STEERING COLUMN COVER
|
 |
- Detach the 4 clips.
Detach the claw to remove the upper steering column cover.
| 3.
REMOVE TRANSPONDER KEY AMPLIFIER |
 |
- Using a screwdriver, widen the claw attached to the upper bracket by approximately 1.0 mm (0.039 in.).
Pull out the transponder key amplifier with the claw open.
Disconnect the connector and remove the transponder key amplifier.