2011-2013 Land Cruiser · Service Manual Vehicle Interior

REPLACEMENT

Removal / installation · Vehicles built from Sep 2011

NOTICE:
Take extra care when handling these precision electronic components.


1. REMOVE TRANSMITTER HOUSING COVER

  1. B225782E01
    Twist a screwdriver in the direction of the arrow in the illustration and remove the transmitter housing cover.

    NOTICE:
    Do not forcibly pry open the cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


2. REMOVE DOOR CONTROL TRANSMITTER MODULE

  1. B137124E01
    Using a precision screwdriver, remove the door control transmitter module.

    NOTICE:
    When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE TRANSMITTER BATTERY

  1. B102246
    Twist a coin in the direction of the arrow in the illustration and remove the transmitter battery cover.

    NOTICE:
    When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

  1. B102247
    Remove the battery (lithium battery: CR2016).

    NOTICE:
    1. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.
    2. Do not push the terminals with your finger.
    3. Do not forcibly pry up the battery. The terminals may become damaged.
    4. Do not touch the battery with wet hands. Water may cause rust.
    5. Do not touch or move any components inside the transmitter. the transmitter may cease to work.


4. INSTALL TRANSMITTER BATTERY

  1. B102768
    Install a new battery (lithium battery: CR2016) with the positive (+) side facing upward as shown in the illustration.

    NOTICE:
    1. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.
    2. Be careful not to bend the transmitter battery electrode during insertion.
    3. Keep the transmitter battery cover interior free of dust and oil.

  1. B137137
    Install the transmitter battery cover.

    NOTICE:
    When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.


5. INSTALL DOOR CONTROL TRANSMITTER MODULE

  1. B137125
    Install the door control transmitter module.

    NOTICE:
    When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.


6. INSTALL TRANSMITTER HOUSING COVER

  1. B225783
    Install the transmitter housing cover to the transmitter housing case.

  1. Check that the transmitter LED illuminates 3 times when a switch is pressed 3 times.

← REPLACEMENT (from Jan 2012)COMPONENTS (Sep 2011 – Dec 2011) →