INSPECTION
Inspection · Vehicles built from Jan 2012
| INSPECT NO. 2 EMISSION CONTROL VALVE SET |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 5
20°C (68°F)
4.5 to 5.5 Ω
1 - Body ground
Always
1 MΩ or higher
5 - Body ground
Text in Illustration *a
Component without harness connected
(No. 2 Emission Control Valve Set)
- HINT:
- When measuring the resistance, do not touch terminals 2, 3 or 4.
- When measuring the resistance, make sure that the surface temperature of the No. 2 emission control valve set is 20°C (68°F).
- When measuring the resistance, do not touch terminals 2, 3 or 4.
Check the operation of the No. 2 emission control valve set.
Check that air does not flow from port A to port B.

Text in Illustration *1
Port A
*2
Port B


Air
- NOTICE:
- Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.
Apply battery voltage across terminals 1 and 5.

- NOTICE:
- When applying voltage, do not touch terminals 2, 3 or 4.
Check that air flows from port A to port B.
If the result is not as specified, replace the No. 2 emission control valve set.Text in Illustration *1
Port A
*2
Port B
*a
Component without harness connected
(No. 2 Emission Control Valve Set)


Air
