C15F0 VFC Solenoid Circuit
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
This circuit supplies electric power to the power steering solenoid valve.The power steering ECU controls the output current to the power steering solenoid valve in accordance with the steering angle signal, VGRS relative angle signal, steering zero point memory, vehicle speed signal and engine speed signal, adjusting the amount of power steering assist.
| DTC Code |
DTC Detection Condition |
Trouble area |
| C15F0 |
A short or open in the solenoid valve circuit. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING GTS (SOLENOID CURRENT) |
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / PPS / Data List.
PPS Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Solenoid Current
Solenoid Current/
Min.: 0 mA
Max.: 1000 mA
200 to 950 mA
The engine is running and the steering wheel is being turned.
- OK:
- The normal condition value is displayed on the GTS.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - POWER STEERING SOLENOID VALVE) |
Disconnect the E102 power steering ECU connector.
Disconnect the C149 power steering solenoid valve connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E102-7 (SOF+) - C149-2 (SOF+)
Always
Below 1 Ω
E102-8 (SOF-) - C149-1 (SOF-)
E102-7 (SOF+) - Body ground
Always
10 kΩ or higher
E102-8 (SOF-) - Body ground
|
|
||||
| OK | |
| 3. INSPECT POWER STEERING SOLENOID VALVE ASSEMBLY |
![]() ![]() |
Disconnect the C149 power steering solenoid valve connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (SOF-) - 2 (SOF+)
20°C (68°F)
6.7 to 7.3 Ω
Connect the positive (+) lead of the battery with a 21 W bulb to terminal 2 (SOF+) and the negative (-) lead to terminal 1 (SOF-) of the solenoid valve connector. Then check that the valve moves and makes an operating noise.
- OK:
- Valve moves and makes an operating noise.
Text in Illustration *a
Component without harness connected
(Power Steering Solenoid Valve)
|
|
||||
| OK | ||
| ||

