2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012


1. REMOVE PROPELLER SHAFT HEAT INSULATOR

  1. C172294E01
    Remove the 2 bolts and insulator.


2. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

  1. A218713
    Disconnect the heated oxygen sensor connector.

  1. A218714E01
    Using SST, remove the heated oxygen sensor from the front No. 2 exhaust pipe.
    SST
    09224-00010  


3. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

  1. A218716
    Detach the clamp and disconnect the heated oxygen sensor connector.

  1. A218717E01
    Using SST, remove the heated oxygen sensor from the front exhaust pipe.
    SST
    09224-00010  


4. REMOVE TAILPIPE ASSEMBLY

  1. A272604
    Remove the bolt and exhaust tailpipe clamp.

  1. Remove the 2 exhaust pipe supports, gasket and tailpipe.


5. REMOVE EXHAUST PIPE DAMPER

  1. A218620
    Remove the 2 bolts, exhaust pipe damper and No. 4 exhaust pipe upper protector from the tailpipe.


6. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 4 bolts and disconnect the center exhaust pipe.

  1. Remove the 3 exhaust pipe supports, 2 gaskets and center exhaust pipe.


7. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

  1. A209554
    Remove the 2 nuts and front No. 2 exhaust pipe.

  1. Remove the gasket.


8. REMOVE FRONT EXHAUST PIPE ASSEMBLY

  1. A209555
    Remove the 2 nuts and front exhaust pipe.

  1. Remove the gasket.

← COMPONENTS (from Jan 2012)INSTALLATION (from Jan 2012) →