DATA LIST / ACTIVE TEST
System information · Vehicles built Sep 2011 – Dec 2011
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / Parking Assist Monitor System / Data List.
According to the display on the tester, read the Data List.
Parking Assist Monitor System Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
AVC-LAN Master Connect Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
AVC-LAN Master Reset Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
AVC-LAN Master Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
AVC-LAN Connect Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
AVC-LAN Sending Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
AVC-LAN Regist Complete Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
AVC-LAN Regist Request Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
ON/OFF Parameter Status
AVC-LAN communication condition/OK or NG
OK: AVC-LAN communication condition is normal
NG: AVC-LAN communication condition is abnormal
-
VGRS With or Without Status
Displays "Parking Assist ECU's internal data may or may not match the "with/without VGRS" data that has been input" /OK or NG.
OK: Data Verification Normal
NG: Data Verification Abnormal
-
Destination Data Check
Verification of Destination Data/OK or NG
OK: Data Verification Normal
NG: Data Verification Abnormall
-
EEPROM Status (Initial read)
Parking assist ECU information/ OK or NG
OK: Parking assist ECU is normal
NG: Parking assist ECU is abnormal
-
IG Voltage Low Status
IG voltage input to parking assist ECU/OK or NG
OK: IG voltage is normal
NG: IG voltage is abnormal (too low)
-
IG Voltage High Status
IG voltage input to parking assist ECU/OK or NG
OK: IG voltage is normal
NG: IG voltage is abnormal (too high)
-
ACC Voltage Low Status
ACC voltage input to parking assist ECU/OK or NG
OK: ACC voltage is normal
NG: ACC voltage is abnormal (too low)
-
ACC Voltage High Status
ACC voltage input to parking assist ECU/OK or NG
OK: ACC voltage is normal
NG: ACC voltage is abnormal (too high)
-
AISIC Output Status
Output condition of camera display signal/OK or NG
OK: Output condition of camera display signal is normal
NG: Output condition of camera display signal is abnormal
-
VGRS Relative Angle Status
Displays "VGRS may be active or inactive" /OK or NG
OK: VGRS normal
NG: VGRS abnormal
-
Wheel Speed Sensor (4wheel)
Effectivity of speed signal from speed signal sensor/OK or NG
OK: Speed signal is effective
NG: Speed signal is not effective
-
Number of DTC
Number of stored trouble codes/min.: 0, max.: 255
Number of DTCs will be displayed
-