2011-2013 Land Cruiser · Service Manual Power Source / Network

U1117 Lost Communication with Accessory Gateway

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Also covers:

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U1117
There is no communication from the bus buffer ECU
  1. Bus buffer branch wire or connector
  2. Accessory bus buffer
B2779
There is no communication from the bus buffer ECU
  1. Bus buffer branch wire or connector
  2. Accessory bus buffer

WIRING DIAGRAM

C140665E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (ACCESSORY BUS BUFFER BRANCH WIRE)
E207355E01
  1. Disconnect the E6 accessory bus buffer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E6-1 (CAN+) - E6-2 (CAN-)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Accessory Bus Buffer)



NG
REPAIR OR REPLACE ACCESSORY BUS BUFFER BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK

REPLACE ACCESSORY BUS BUFFER


← U1115 Lost Communication with Tilt and Telescopic Module (from Jan 2012)U1117 Lost Communication with Accessory Gateway (+ B2779) (from Jan 2012) →