2011-2013 Land Cruiser · Service Manual Vehicle Interior

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL CENTER CLUSTER MODULE LENS

  1. E211300E01
    Remove the double-sided tape from the control knob sub-assembly.
    Text in Illustration 
    *1
    Double-sided Tape

  1. Wipe off any tape adhesive residue with cleaner.

  1. Remove the peeling paper from a new center cluster module lens.

    HINT:
    After removing the peeling paper, keep the exposed adhesive free from foreign matter.

  1. Install the center cluster module lens.

    NOTICE:
    Do not reuse the center cluster module lens after removing it.


2. INSTALL HEATER CONTROL KNOB

  1. E211299
    Attach the 8 claws to install the heater control knob.


3. INSTALL HEATER CONTROL GUARD

  1. E211298E01
    Install a new heater control guard.
    Text in Illustration 
    *1
    Heater Control Guard


4. INSTALL CENTER CLUSTER MODULE CIRCUIT

NOTICE:
As the electronic parts of the circuit board may be damaged by static electricity, do not touch the electronic parts of the circuit board or the soldered areas with bare hands.

  1. E211296
    Install the center cluster module circuit with the 2 screws.


5. INSTALL LOWER HEATER CONTROL BASE

NOTICE:
As the electronic parts of the circuit board may be damaged by static electricity, do not touch the electronic parts of the circuit board or the soldered areas with bare hands.

  1. E211297
    Install the 3 screws.

  1. E211295
    Attach the 6 claws to install the lower heater control base.

← DISASSEMBLY (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →