2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT BACK DOOR LOCK ASSEMBLY

  1. B292779E01
    Check the operation of the door lock motor.

    1. Apply battery voltage to the door lock motor connector and check the operation of the door lock motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2 (ACT+)
      Battery negative (-) → Terminal 3 (ACT-)
      Lock
      Battery positive (+) → Terminal 3 (ACT-)
      Battery negative (-) → Terminal 2 (ACT+)
      Unlock

      If the result is not as specified, replace the back door lock assembly.
      Text in Illustration 
      *a
      Lock
      *b
      Unlock
      *c
      Component without harness connected
      (Back Door Lock Assembly)

  1. Check the detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 (S) - 4 (E)
      Lock
      10 kΩ or higher
      Unlock
      Below 1 Ω

      If the result is not as specified, replace the back door lock assembly.

  1. Check the operation of the door courtesy switch.

    B292780E01

    Text in Illustration 
    *a
    Component without harness connected
    (Back Door Lock Assembly)
    *b
    Full Latch
    *c
    Half Latch
    *d
    Open

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (E) - 2 (+)
      Open
      Below 1 Ω
      Half Latch
      Below 1 Ω
      Full Latch
      10 kΩ or higher

      If the result is not as specified, replace the back door lock assembly.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →